Linksys wet11 setup wizard
Setup Setup | Password | Advanced | Status | Help This screen allow changes to basic settings. Click the Apply button to save any changes. If this page does not automatically refresh after clicking Apply, then click the Refresh button of your web browser.: Firmware. Re: wet11 set-up disk. 1. Try to reset the device again for 20 to 30 seconds and power cycle. 2. Connect your Wet11 hardwire to the any available Ethernet port of your router. 3. Log into your router's DHCP client table and check if your Wet11 is detected. If it is detected, ping the IP address that is assigned to your Wet To configure any other Wireless-B Ethernet Bridges on your network, run this Setup Wizard again. To register the Bridge, click the Online Registration button. To exit the Setup Wizard, click the Exit button. The Wireless-B Ethernet Bridge is now successfully configured for your network.
Between us speaking, I would try to solve this problem itself.
It is a valuable phrase